Large 50g Everbuild Industrial Superglue
HV High Viscosity
High viscosity flash setting industrial adhesive
based on advanced cyanoacrylate technology.
Flash setting formulation,
bonds to most porous and non porous surfaces in seconds.
Fills gaps up to 0.25mm
Single component adhesive
100% solvent free
Economical in use
Limitations
Ensure surfaces are degreased prior to bonding.
Ensure surfaces are close fitting.
This adhesive will not bridge gaps
Do not use on glass.
Do not use in applications involving constant water immersion.
Do not use on bitumen or tar leaching products.
As the manufacturer cannot know all the uses its products may be put to, contact technical services for advice if in any doubt.
Application
The surfaces to be glued should be clean, dry and free from dust, grease and other contaminants. Materials should be stored in a warm environment prior to bonding to avoid chilling of the glue line, which leads to extended setting times. Where possible, ensure working environment has a relative humidity of 50% +.
Apply adhesive to one surface only. Press surfaces together and hold for 10 seconds or as indicated below. Cure speed is rapid so exercise care when aligning.
Form
|
Clear liquid.
|
Viscosity
|
100-120 poise
|
Base
|
Ethyl Cyanoacrylate
|
Solids
|
100% Active
|
Specific Gravity
|
1.05
|
Flash Point
|
>85 Degrees C
|
Tensile Strength
|
28-32Nmm2 (steel-steel ASTM D2095)
|
Shear Strength
|
15-20Nmm2 (steel-steel ASTM D1002)
|
Impact Strength
|
1.8-2.0Nmm2 (steel-steel ASTM 950)
|
Refractive index
|
1.46 (cured adhesive)
|
Hardness
|
82 (Rockwell cured adhesive)
|
Specific resistance
|
8 x 1012 OHM/cm (cured adhesive)
|
Dielectric Const.
|
3.44 @ 1MHZ (cured adhesive)
|
Softening Point
|
150OC
|
Working temps.
|
-60 to +80oC
|
Setting times
|
5-60 seconds (plastic to plastic)
2-20 seconds (rubber to rubber)
10-60 seconds (degreased metal to metal)
|
Toxicity
|
Non toxic
|
No reviews have been left for this product, be the
first to
leave a review